|
#1
|
|||
|
|||
Fanning the Hammer on a single-action revolver
Can this be done with any single-action revolver, or only on older ones that don't have modern internal safeties?
|
#2
|
|||
|
|||
I think you can fan most revolvers with an external hammer, not just SA ones (although it is pointless on DA/SA revolvers I think it is still mechanically possible). You really shouldn't do it though as it is very hard on the gun. Because you are driving the hammer back at much greater speeds than normal cocking it basically increases the forces on all the internal components greatly accelerating wear.
I remembering hearing that cowboy trick shooters use modified strengthened revolvers for fanning. Even with this they still need three revolvers: one to shoot, one as a spare, and the third is being rebuilt at a gunsmiths. |
#3
|
|||
|
|||
Quote:
|
#4
|
|||
|
|||
Yeah, trick shooters and quick draw artists who do fanning tend not to use standard guns. The fanning causes great wear on the components and risks causing the gun to go out of time. I've even seen a double-action blank gun that was broken completely by someone fanning it.
|
#5
|
||||
|
||||
Would you be able to fan a revolver with a transfer bar, like a Ruger Vaquero?
__________________
"Me fail English? That's unpossible!" |
#6
|
|||
|
|||
It should do, the transfer bar is simply a piece of metal that is linked directly to the trigger. When you pull the trigger the transfer bar slide upwards behind the firing pin (if it wasn't there the hammer wouldn't reach the firing pin hence wouldn't fire), assuming you continue to hold the trigger all the way back the transfer bar would stay in the firing position. There is no disconnect or anything like that that means it goes back to the safe position after firing and the trigger needs to be reset to get it back to the firing position.
|
|
|