Quote:
Originally Posted by Yournamehere
Cool videos, what kind of camera do you use?
I also had a hangup in my Springfield similar to the first one, only the casing was still in the extractor. If you find out what the problem is, let me know cause it might have something to do with my gun too.
|
JVC Everio GZ-HM30, it shoots in 720p. I like alright. I just wish the video software was a little better. Editing wise.
Well I was running an 18lb spring, some say that might have been one of the causes. I had never took out the extractor to clean in, the tunnel was pretty dirty. I'll do an update when I take it out again.
Quote:
Originally Posted by Gunmaster45
I noticed in your grip that you keep you thumb really high up. I was taught not to do that to avoid touching the slide and causing stoppages, as well as they say keeping your thumb pointed forward kind of helps guide you on the target better, since you're basically pointing at it.
But if it works for you, it works for you.
|
Yeah I noticed that, I may try to point my thumb forward more. (for better pointability) I don't think it caused the malfunctions since I used the same grip on the other guns.
Quote:
Originally Posted by BurtReynoldsMoustache
Nice shades, what brand are they?  |
Von Zippers I think.
Quote:
Originally Posted by k9870
I was taught high thumbs, on a sig thumbs forward will ride the slide stop and cause failure to lock back. I shoot crossed thumbs now though.
|
I used to shoot with the thumb low (bottom rear of the grip panel). But when I compared the two (after finding out about high thumb). I immediately switched to it. I'm going to try to take the P220 out next time. I'll see if I have to switch to low thumb, probably will have to.